,: Align segments; Alt-click: Clear selectionUAligns the way segment to the reference so that its length is preserved.īAligns the way segment to the reference so that the angles of its adjacent segments are preserved.
The length of the aligned segment is likely to change as result.
Last hint: There is an easy way to start over your selections if you want: Alt-Click somewhere on the map.
"
9
z
/

AlignWays will help you to align two way segments. This can be handy when for instance you sketch the outlines of a building and want its side to be parallel with a street or road.

Some tips may help before you start:

+Added angle preserving aligning modeAlign Way SegmentsAlign Way Segments: Modes Align WaysAlign Ways control panelAlign Ways modeAlign way segment Align with:AlignWayS message!AlignWayS: Alignment not possibleAlignWays TipsAlignWays: What''s New...KAligning would result nodes ''outside the world''. Alignment not possible. ^An intersection point would fall outside its adjacent nodes. This is an unsupported scenario. Angle preservedBrowser not supported.CClick: select way segment to be aligned; Alt-click: Clear selectionDCtrl-Click: select reference way segment; Alt-click: Clear selectionQCtrl-Click: select reference way segment; Click: select way segment to be alignedQCtrl-click: select reference way segment; Click: select way segment to be alignedDon''t show this againErrr... I''m ready!Length preserved]Makes a pair of selected way segments parallel by rotating one of them around a chosen pivot. Mode: {0}"Parameter ''{0}'' must not be nulljPlease select two segments that don''t share any nodes. Alternatively put the pivot on their common node. _Please select two segments that don''t share any nodes or put the pivot on their common node. qReference segment cannot be the same with the segment to be aligned. Please choose a different reference segment.uSegment to be aligned cannot be the same with the reference segment. Please choose a different segment to be aligned.ĚThe alignment is not possible with maintaining the angles of the joint segments. Either choose the ''keep length'' aligning method or select other segments. éThere is at least a non-pivot endpoint of the alignee that joins more than two way segments. Preserved angles type alignment is not possible. (This panel activates in Align Ways mode: Tool: {0}Undocumented problem occured. !Various improvements and bugfixesWelcome to the
AlignWayS Plugin

...or it rather should be called
AlignWayS(egments) Plugin...What''s new...ˇˇ